- Outras empresas da Fluke:
- Fluke
- Fluke Biomedical
- Fluke Networks
- Fluke Process Instruments
Design and Evaluation of Pressure Balances for the Boltzmann Constant Project
In support of the project for determination of the Boltzmann constant by dielectric constant gas thermometry a system of pressure balances has been designed and constructed with the goal of defining pressures in helium in gauge and absolute measurement modes up to 7 MPa with a relative standard uncertainty of 1∙10-6. The design supports this reduced uncertainty with focus on the areas of temperature stability, mass uncertainty, effective area and pressure distortion coefficient. The system includes two pressure balance platforms, three 20 cm2 and three 2 cm2 piston-cylinder assemblies (PCAs) and automated mass handlers. The design of the PCAs and of their mounting was optimized to reduce pressure distortion coefficients and mounting induced deformations. The PCAs gap width was adjusted to reach an optimal compromise of fall rate and sensitivity. In order to perform automated cross-floats with the pressure balances with a possibility of different gases and a high level of cross-float sensitivity, differential pressure cells (DPCs) were applied to indicate pressure equilibrium. The pressure balances have similar performance with both nitrogen and helium. For any pair of the PCAs, comparisons conducted by automated cross-floats demonstrate repeatability of area ratios within (0.2 to 0.5)∙10-6 up to 7 MPa. The effective area ratios obtained from cross-floats for all possible combinations of PCAs are consistent within 0.96∙10-6. Using dimensional measurements, the effective area of the 20 cm2 and 2 cm2 PCAs were determined with relative standard uncertainties of 0.7∙10-6 and 1∙10-6, respectively. Based on the currently available dimensional and cross-float data the relative standard uncertainty of the absolute pressure of 7 MPa is equal to 2.1∙10-6.
- Início
- Produtos
- Novos Produtos
- Calibração elétrica
- Calibração de RF
- Equipamento de aquisição de dados e de teste
- Calibração de temperatura
- Calibração de umidade
- Calibração de pressão
- Medidores de pistão
- Controlador/Calibradores
- Monitores de pressão
- Balanças de peso morto
- Calibradores manuais e monitores
- Handheld Pressure Calibrators
- Calibração de dados de aéreos
- Monitores ambientais
- Acessórios de calibração de pressão
- Sistemas personalizados de calibração de pressão
- Software de calibração de pressão
- Calibração de fluxo
- Ferramentas de Calibração de processo
- Software de calibração
- Serviço e suporte
- Todos os instrumentos de calibração
- Onde Comprar
- Notícias
- Treinamento e eventos
- Literatura e educação
- Serviço e Suporte
- Service Request (RMA)
- Planos de Serviço
- Suporte técnico
- Base de Conhecimento
- Acreditações
- Centros de assistência autorizados
- Calibration Certificates
- Community Forum
- My MET/SUPPORT
- Manuais de produto (Guias de usuário)
- Folhas de Dados de Segurança (SDS)
- Safety, Service, and Product Notices
- Downloads de software
- Sobre Nós